Send Address Settings]. Open the automatic document feeder (ADF) cover on the scanner to check. An error has occurred while connecting to a file server. Turn the machine off.
Scan To PC Problems Insufficient Memory occurred during Rx. How to log in as the administrator About the Web Page of the Printer Click [Network Setup] on the [Admin Setup] tab. PDF Manual OKI B6500_.pdf. Deleting encrypted authentication print data. http://www.okidata.com/documents/support/user-documentation/MB472/English/contents/search_err_msg.html
Toner cartridge not properly installed. Check the wireless access point settings, and then perform the manual settings or automatic settings. Wait for a while. Writing to USB Memory failed.
If you have any questions, contact your dealer. RFID Reader I/F ... Check the access rights for the shared folder. Oki Error 461 Power OFF/ON Carriage Error <1> Indicates that a carriage error has occurred.
Reset Paper in [TRAY]. Oki Troubleshooting Check network configuration, cable connection and status, and the server status. Use a toner cartridge that matches your machine. http://www.okidata.com/documents/support/user-documentation/MB472/English/contents/qa_000019.html Try it again.
Check the SMTP server setting. Oki B431dn Error 563 Drum Life Cannot connect to the POP3 server. An error has occurred in the image data sent to this machine. Check the file format and size of the attached file.
An optimum M (Magenta, red) toner cartridge is not installed. look at this web-site Please check Network Share Name. Oki Error Codes Load the indicated size paper. Oki Printer Toner Sensor Error Reduce the print resolution set for the print data that caused this error.
C: Cyan (blue), M: Magenta (red), Y: Yellow, K: Black Toner cartridge not installed. Check the type of the specified paper. This action is not supported. Waste Toner Full Replace with new Toner Cartridge. Tray Media Mismatch 461 Oki
If you set [Authentication Method] to [POP], set [POP3 Server], [POP3 UserID], [POP3 Password], [POP3 Encryption], [POP3 Port Number], and [APOP Support]. Contact the administrator. Connect to PC failed. If the same error occurs, contact your dealer.
If SSL is enabled, make sure that the SSL port number is correctly set. Oki B4600 Toner Not Installed Error If the same error occurs, contact your dealer. Wait for a while.
Please call service. [CODE] Indicates that a lamp error has occurred. Toner empty. Multi-purpose tray has not been set to be used as the tray, so multiple copies have been printed. Oki Toner Sensor Error Note If you specify a domain name in [SMTP Server], you must set the DNS server for the [TCP/IP] setting.
FTP destination Full. USB Memory Full USB Memory is full and cannot store data. Repair or replace the device, and then retry. A USB hub is connected.
Change the MP tray setting. Error:984, 685, 686, 687, 690, 691, 692, 693, 700, 701, 702, 703, 704, 705, 706, 707 Non-optimum image drum is installed. File Transmission Error A file transmission error has occurred. Please check POP3 settings.
Accounting Log buffer is near full. Remove and re-install the fuser unit. Check the network settings. Error: 014 Memory full error has occurred during PC Fax reception.
C: Cyan (blue), M: Magenta (red), Y: Yellow, K: Black Image Drum Sensor Error Check Image Drum. Rear Output Tray was opened during printing. Install the image drum. Please check data.
Waste Toner Full Replace with new Toner Cartridge. If the cassette is already inserted in the printer, pull out the cassette and close it again correctly. Please try the request again. If you do not need to set [Security Settings] and [Configure attached information], proceed to step 15.
If the error still persists, contact your service representative. Or, contact your dealer.